Dog Fence Lightning Protection Dog Fence/Training Collar Combo Unit Frequently Asked Pet Fence Questions
Pet Fence Perimeter Example Diagrams
Recommended by Pet Professionals
Replacement Batteries & Collar Straps
Pet Professionals in Kansas City
Powered by ServiceMagic
Financing only available to residents in the states of Kansas & Missouri.
|
|
Indoor Pet Fence systemsIT-200 Indoor Transmitter The IT-200 Indoor Transmitter can be used with or without a boundary wire. The IT-200 should be used in conjunction with a Pet Stop® battery- powered receiver collar or another compatible pet containment receiver.
When operated as a wireless transmitter, the signal field radiates up to approximately seven feet from the unit. When used as a wired unit, the transmitter emits a maximum signal field of approximately four feet on either side of the indoor boundary wire. The maximum signal field will vary depending on the configuration of the boundary wire. The IT-200 activates the Pet Stop collar to train your pet to stay away from an area or a piece of furniture. The Pet Stop collar will administer a mild correction whenever your pet enters the area protected by the IT-200.
The IT-200 Transmitter is designed for indoor use only.
Under normal operation, the IT-200 Transmitter will display the signal field strength number (such as “10”) and will make no sounds. This indicates the IT-200 is operating normally. You may make adjustments to the signal field range to obtain the correction zone you desire. Pressing the upper button (“+”) will increase the signal field to a maximum of 32. Pressing the lower button (“-”) will decrease the signal field to a minimum of 1. Note that the IT-200 will not detect a break in the wire if the setting goes below 6. A recommended starting point for the signal field range is 15. If the signal field interferes or encroaches on your pet’s safety zone lower the signal field range. To create a larger correction zone increase the signal field range. If the transmitter detects a break in the boundary wire the signal field Range Display will begin to blink and an audio alarm will sound. Receiver: The Pet Stop® collar will activate by emitting a beep and then administering a correction when it enters the signal field. The signal field is the area in front of and behind the wire in wired mode and the area radiating from the transmitter in wireless mode. The receiver will continue to activate while it is in the signal field for a period of 20 seconds. It will then shutdown until it is removed from the signal field. This Safety Stop® feature is designed to protect the pet in case it gets stuck in the signal field. The receiver has a low battery indicator. When the red indicator light on the front of the receiver begins to flash the battery should be changed immediately. The red light does not activate during normal operation.
|
|||||
|
|||||||